Winland-electronics EA800-ip Instrukcja Użytkownika Pobierz pdf (Strona 43)

Maintenance

D-011-0152 43

Replacing a Sensor

The EA800 allows you to replace an existing, programmed wireless sensor with another of the same type. When

replaced, the original sensor’s programmed settings and parameters are retained and applied to the new sensor. If

you need to change settings other than those provided in the Edit Sensor screen, you must delete the existing

sensor and then add the replacement sensor.

Note: See “Pausing Monitoring and Cancelling Pause” on page 42 to pause the console before you begin so

you can replace the sensor without tripping the alarm.

Note: If adding more than one sensor, add them to the system one at a time. Power on one sensor and add it to

the system, then power on the next sensor and add it. Do not power on all sensors at the same time.

To replace an existing wireless sensor:

1. Physically replace the sensor with another of the same type and ensure it is powered on.

2. Perform the procedure shown below to allow the console to search for the new sensor:

3. Select the detected sensor from the SELECT SENSOR screen. If the detected new sensor is the same type as the

replaced sensor, the SENSOR REPLACED screen is displayed.

4. Press OK (F3) to return to the SENSORS screen. If the replacement sensor

appears in the list, highlight it and press Accept. If it does not appear in the list,

press Cancel (F1) to continue the search process.

5. If the detected new sensor is not the same type as the replaced sensor, the

INVALID SENSOR TYPE screen is displayed. Press OK (F3) to return to the

SENSORS screen:

6. Do one of the following:

• Replace the physical sensor with one that matches the type of the

replaced sensor and repeat this procedure.

• Delete the sensor from the console and replace with the new sensor (of a different type). See “Deleting

a Sensor” on page 45 and “Adding Wireless Sensors” on page 29.

7. If you wish to replace another wireless sensor, repeat this procedure.

8. If you are finished performing sensor maintenance, press to exit maintenance and resume monitoring.

9. Press F1 to lock the keypad.

Unlock the EA800 as shown

in “Locking and Unlocking

the EA800” on page 41

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Brak uwag

Winland-electronics EA800-ip Instrukcja Użytkownika Strona 43